Thursday, October 12, 2017

Juno: Configuring VLANS and Trunking on the EX-series Switch

1. From configuration mode create the VLAN and add access interface to it:  

root> configure
Entering configuration mode

[edit]
root# set vlans <vlan-name> vlan-id <vlan-id (1..4095)>
root# set interfaces ge-0/0/<port#>.0 family ethernet-switching port-mode access vlan members <vlan-name>
root# commit 


2. Verify the VLAN and interface:
root# run show vlans
-------------------------------------------------------
Name           Tag     Adress            Ports
                                       Active/Total
-------------------------------------------------------
bar           67      ---------           0/0
default       None    ---------           3/5
foo           66      ---------           1/1

 
root# run show ethernet-switching table | except :

  VLAN              MAC address       Type         Age Interfaces
  foo               *                 Flood          - ge-0/0/5.0
  bar               *                 Flood          - ge-0/0/16.0, ge-0/0/15.0
  default           *                 Flood          - ge-0/0/0.0, ge-0/0/1.0, ge-0/0/2.0

 
root# run show ethernet-switching interfaces
Interface   Index    State     VLAN members
ge-0/0/0.0  69       UP        default
ge-0/0/1.0  70       UP        default
ge-0/0/5.0  71       UP        foo

 
root# show ethernet-switching interfaces detail
Interface: ge-0/0/0.0 Index: 69
  State: UP
  Vlans: default(untagged)

Interface: ge-0/0/1.0 Index: 70
  State: UP
  Vlans: default(untagged)

Interface: ge-0/0/5.0 Index: 71
  State: UP
  Vlans: foo(untagged)
  3. Configure the TRUNK and add VLAN that was created in previous steps:
root# set interfaces ge-0/0/<port#>.0 family ethernet-switching port-mode trunk [native-vlan-id <id>] vlan members [ whitespace separated list of vlan names or IDs ]

root# commit

4, Verify the TRUNK and the VLAN members for this trunk:
root# run show interfaces ge-0/0/<port#>.0
Flags: Trunk-Mode <---

root# run show ethernet-switching interfaces
Interface   Index    State     VLAN members
ge-0/0/2.0  71       UP        my-vlan, mydefault, pfetest

No comments:

Post a Comment

Juniper EX-3400 VC

Easiest way to stack two EX3400's is make sure they are on the same code level. Then connect them using the QSFP+ ports. Boot the master...