Telnet into those ports which seems to connect on both. I ran nmap to verify the ports were open from the guest client to the controller. The following ports were open that should be associated with the UniFi controller:
8080
8443
8843
8880
I **think** that I am doing what you want. I run my own controller on my
LAN at 192.168.16.14. I have a VLAN-capable firewall, but no VLAN
switch. I created a VLAN with three ports of my firewall (one is the
uplink to non-VLAN switch; two are for UAP connections). I set up a
matching VLAN for the guest SSID on my two UAPs, and I have my inform
address as a public FQDN. My firewall is set to allow loopback
processing, so when a guest tries to reach the portal, traffic goes
"out" the firewall and back "in" to the WAN IP via the FQDN lookup in my
public DNS. That way, there is no LAN traffic needed to reach the
controller for the guest portal, and it works with the guest in its own
VLAN.
Yeah that's pretty close, the difference is that we do some tagging on
the switch as well, but we've confirmed that traffic is flowing already
so I'm less concerned now about the VLAN tagging now than I am the
firewall itself and it being an ASA not allowing loopback. The strange
thing is that everything still seems to be getting through though port
wise.
Unfortunately support hasn't been able to help yet.
Subscribe to:
Post Comments (Atom)
Juniper EX-3400 VC
Easiest way to stack two EX3400's is make sure they are on the same code level. Then connect them using the QSFP+ ports. Boot the master...
-
The problem with OpenJDK working on Ubuntu 17.04. To make it work you have to install Oracle Java. To do this type in terminal: sudo ad...
-
04-10-2017 03:01 PM @bravonoj And a few more tests for you to try: 1. Make sure DNS works...
-
Juno Virtual Chasis OS Upgrade 1. sort switches by serial #, smallest on top. 2. connect switches with DAC cables (...
No comments:
Post a Comment