Wednesday, October 20, 2021

Juniper EX-3400 VC

Easiest way to stack two EX3400's is make sure they are on the same code level. Then connect them using the QSFP+ ports. Boot the master unit first. Then boot a blanked secondary unit. Give it a few minutes, but a stack will form. Then assign roles and build the config.

https://www.reddit.com/r/Juniper/comments/lccqui/juniper_virtual_chassis_ex3400/

If the two switches are physically co-located, then acquiring a pair of DAC cables would be best. But, you can certainly use SFP+ ports instead.

You will need to wipe the config on the second. Setup the virtual-chassis config on the primary as preprovisioned. List both serial numbers of both devices. Copy the config from the seconday, and add it as additional config to the primary, AFTER having edited all of the interfaces to be 1/x/x instead of 0/x/x.

Yes JunOS will let you configure interface config for interfaces that do not exist (yet.)

You'll also want to delete all of the system config and other non-interface config before you add it to the primary.

Get the secondary to the same software version as the primary, it's just easier. Wipe the config. Request the desired interfaces to be VC ports on the secondary. Power it down. Request the desired interfaces on the primary to be VC-ports. Connect the VC-port interfaces. Power-up the secondary.

No comments:

Post a Comment

Juniper EX-3400 VC

Easiest way to stack two EX3400's is make sure they are on the same code level. Then connect them using the QSFP+ ports. Boot the master...